FRP Plate & Fiberglass Solid Flat Sheet
FRP plate is a solid fiberglass flat sheet with a smooth gel-coat surface used for linings, panels, covers and corrosion-proof construction where open mesh is unsuitable.

FRP plate is a solid, flat fiberglass reinforced sheet with a resin-rich gel-coat surface that resists chemicals, moisture and corrosion.
It is used for tank and wall linings, equipment panels, covers, splash guards and structural facing where a solid, cleanable surface is needed instead of open mesh.
Sheets are supplied in a range of thickness, colors and finishes, and can be cut and fabricated with standard tools.
Key Benefits
- Solid smooth surface that is easy to clean
- Strong chemical and corrosion resistance
- Will not rust or rot
- Range of thickness, color and gel-coat finishes
- Easy to cut and fabricate
Typical Specifications
| Material | FRP / GRP solid sheet |
| Thickness | 1–8 mm, custom |
| Surface | Smooth gel coat |
| Sheet size | 1000×2000 / 1220×2440 mm |
| Finish | Gloss / matte |
| Color | White, gray, custom |
| Fixing | Bonding / mechanical |
Common Applications
- Tank and wall linings
- Equipment and machine panels
- Covers and splash guards
- Corrosion-proof facing
- Truck and trailer lining
- Cleanrooms and processing
Frequently Asked Questions
FRP Flooring Sheet in Standard 1220 x 3660 mm Panels
Standard Size, Thickness and Resin
Our FRP flooring sheet is supplied in the standard moulded panel size of 1220 x 3660 mm, which matches the pallet and forklift handling of most industrial floors and racks. Thickness ranges from 3 mm thin cladding up to 5, 8, 10 and 12 mm structural sheet, in isophthalic polyester for general corrosion, vinyl ester for acid and solvent duty, and food-grade white on request. The sheet is impermeable, unlike open grating, so it stops drips and dust through the floor.
Choose thickness by span and load: 3–5 mm for wall and curb lining, 8–10 mm for walkway and equipment platforms, 12 mm where trolleys and pallets run directly on the sheet. We confirm the deflection against your support spacing; see the FRP plate datasheet for the full gauge table.
Anti-Slip Surface and On-Site Cutting
One face is produced with a gritted or chequered anti-slip layer for oily, wet or icy footing, while the reverse is smooth for lining and bonding. The sheet can be drilled, routed and cut on site with carbide tools — no hot work — and edges can be sealed with resin gel-coat to stop water wicking into the glass fibre. Fix it on FRP structural profiles stringers or bond it over concrete.
Pairing With Grating
Use solid sheet where tools, cables or feet must not pass through, and open mini mesh grating where drainage or light is needed; the two can sit side by side on the same frame. Combine with handrail and ladder access on platforms. As an established FRP grating supplier we cut sheets to your drawing, MOQ from 10 m2.
